How to maintain the crawler shot blasting machine
According to the following method of maintenance of crawler shot blasting machine can prolong the service life of shot blasting machine
1, Each class should be tracked Shotblast cleaning again.
2, Should always check the cleaning room in the shield and blasting directional set, impeller wear, such as wear serious, should be replaced immediately.
3, The machine before operation, all moving parts are required bearing lubrication, shot blasting machine spindle, a week 2 # calcium base grease at a time. The spiral conveyor, lifting bearing machine, monthly 2 # calcium base grease at a time. The rest of the bearing every 3-6 months plus a # calcium base grease. Chain and other parts of the activity once a week to add a mechanical oil, motor lubrication requirements on schedule.
4, Regular inspection of each transmission parts, cleaning parts, replacement parts of the wear and tear.
5, Crawler shot blasting machine in the maintenance inspection, the power must be cut off, to prevent accidents.
6, The machine works 48 hours to deal with the wind turbine, and the removal of dust attached to the wheel, in order to ensure the smooth running of the fan and service life.
7, Cleaning room can be replaced periodically according to the situation change, should put the installation gap protecting board piece in 1.5 mm less than control.
8, Track replacement, the front door open, remove all the interference parts, with 10# steel bar to do four bending hook from the upper part of the body of the craft hole will drive shaft and track suspension, the track from the door tilt.