Date:2016-10-25 Visits:118

The highly efficient shot blast wheel requires much less power than competitor's shot blasting machines. Four highly efficient direct drive DISA High Performance shot blast wheels achieve the highest surface finish quality while requiring less power, further reducing cleaning costs. Including abr +Read More

Date:2016-10-08 Visits:142

One of the chief sources of noise at the blast machine is the opening where abrasive is fed to the blast wheel. The SoundAbator totally enclosed abrasive control valve, which can be installed on most Indabrator machine machines,is specifically designed to combat noise from this source by sealing +Read More

Date:2016-10-04 Visits:96

A highly controlled surface treatment process that substantially increases the fatigue life of parts. Shot peening improves the surface properties of metal by impacting the surface with large quantities of round, metallic shot. This process results in compressing and strengthening the surfa +Read More

Date:2016-09-29 Visits:106

During blasting, abrasive media falls at a measured rate through the feeder spout into the blast wheel. The rotating blast wheel picks up the media and accelerates it, creating a blast stream that makes contact with the metal surface. Through the continuous flow of the abrasive media, the metal o +Read More

Date:2016-09-26 Visits:99

The essential element of the shot blasting machine is its particle projection system. The most common type is a turbine using centrifugal force to project a stream of tiny abrasive particles entering at the center of the turbine. The blasting chamber is closed, with a particle recovery system. Ma +Read More

Date:2016-09-26 Visits:106

Shot blasting machine is an environmentally friendly and cost-effective machine to clean large sections of steel or stone surfaces. If you hope a process that cuts down on drying time and offers a surface almost instantly ready for the application of overlays or coatings, shot blasti +Read More

Date:2016-09-26 Visits:95

Sand is the most common abrasive used for shot blasting, and therefore the process is generally referred to as sandblasting. The other abrasives used for shot blasting are garnet, chilled iron, olivine and glass beads. The first two are extremely coarse and abrasive and they are not to be use +Read More

Date:2016-09-26 Visits:101

Workers who carry out the process of shot blasting are exposed to certain hazards and adequate protection is required to keep them safe. One of the most serious hazards is airborne dust which can invade the respiratory system and cause damage. Metal dust can also be very dangerous since metal +Read More

Date:2016-09-24 Visits:90

1. Always check inside the shot blasting chamber, interior linings, etc., should be immediately replaced after wear. 2. Regularly check the wear of blast wheel inside, wear over the limits that should be replaced, especially leaves, directed sets, sub-pill wheel and impeller should pay att +Read More

Date:2016-09-19 Visits:105

The wet sand blasting machine adopts the abrasive fluid as power and transports the well mixed abrasive fluid (abrasives and water) into the nozzle. The compressed air is used as accelerating dynamic to enter into the nozzle through the gas piping. The compressed air speeds up the flow of the +Read More

Date:2016-07-27 Visits:108

Shot blasting machine is a processing technology that steel balls are blasted in a high speed and impacted on surfaces of objects in a high speed. Compared with other processing technologies, the shot blasting machine is more rapid and efficient and can partially keep the casting process afte +Read More

Date:2016-07-15 Visits:90

DISA is offering all types of turbine-wheel shot blasting machines. This includes roller conveyor blasting machines, hanger-type blasting machines, tunnel-type blasting machines (continuous shot blasting machines), rubber belt tumble blasting machines, steel mill tumble blasting machines, diabolo +Read More